View Single Post
Old November 3, 2008, 01:53 AM   #16
Scorch
Senior Member
 
Join Date: February 13, 2006
Location: Washington state
Posts: 15,248
Get a good cleaning rod and a 30-caliber bronze bore brush. Use just about any bore solvent you want. Wet the brush with solvent. Run the brush through the bore several times, then run dry patches through until it comes out clean. The black stuff you are getting out of the bore is probably carbon fouling, the rust colored stuff is the old blueing. If the inside of the bore looks like the outside, you will be fine once you get it cleaned.
__________________
Never try to educate someone who resists knowledge at all costs.
But what do I know?
Summit Arms Services
Scorch is offline  
 
Page generated in 0.03745 seconds with 8 queries