The Firing Line Forums - View Single Post - Correcting the gap between cylinder and forcing cone on '51?

10851Man · January 29, 2013, 06:07 PM

@ Hawg,

I agree on the .010" setting and I had no plans to change it. I just asked about the setting and the wedge screw...

January 29, 2013, 06:07 PM	#43
10851Man Senior Member Join Date: April 20, 2009 Location: High Desert Mountains CA. Posts: 410	@ Hawg, I agree on the .010" setting and I had no plans to change it. I just asked about the setting and the wedge screw...