View Single Post
Old January 13, 2013, 04:56 PM   #14
JN01
Senior Member
 
Join Date: May 16, 2005
Location: E Tennessee
Posts: 828
Quote:
I had a hard time loading the magazine at the correct angle, figuring out when the magazine was completely seated and sometimes I had a hard time getting the bullets to load into the chamber.
Having the cartridges not properly chamber might be related to the magazine not being fully seated. This seems to be a weak point with the 22/45, but is easily corrected.

You just need a thicker base plate that isn't flush with the bottom of the frame. You can purchase replacements, these for example: http://www.tech-custom.com/, or you can fashion your own from rubber or other material and contact cement them to the bottom of the stock base pads. Be sure to leave a hole in the bottom to access the plunger to disassemble the magazine.
JN01 is offline  
 
Page generated in 0.02741 seconds with 8 queries