View Single Post
Old September 8, 2012, 08:00 AM   #19
the led farmer
Senior Member
 
Join Date: July 8, 2012
Location: so cal
Posts: 246
If the disc is extending beyond the frame check your adjustment because it should not. Having your powder through expanding die set too deep causes this, when you actuate the lever it should stop flush and not extend over. This needs to corrected whether or not it's the cause of your current issue. If your spilling powder I am guessing yes, it contributes to your light charges.

This can also give you excessive flare on the case (maybe contributing to your crimp issues?) or flat out buckle them.

Also remember consistency is key, same motions, rotate the turret fully in all 4 stations EVERY TIME you throw a charge etc.

In my experience ball powders work best with lee discs, but I know you said powder is not easy for you to come by
the led farmer is offline  
 
Page generated in 0.04354 seconds with 8 queries