The Firing Line Forums - View Single Post

jimkim · September 8, 2012, 01:08 PM

You may be able to spot any problems if you remove the hopper, and run a case into the charging die. While you're doing this stand over the press and watch the disc from above. When the ram is at TDC you should be looking straight through the disc and into the case.

I really wish I lived nearby so I could help. This type of thread really frustrates me. I hate not being able to help a brother out.

September 8, 2012, 01:08 PM	#27
jimkim Senior Member Join Date: July 3, 2008 Location: middle GA Posts: 326	You may be able to spot any problems if you remove the hopper, and run a case into the charging die. While you're doing this stand over the press and watch the disc from above. When the ram is at TDC you should be looking straight through the disc and into the case. I really wish I lived nearby so I could help. This type of thread really frustrates me. I hate not being able to help a brother out. __________________ Jan. 4, 2007 gasoline $2.10 gal....HMMM?