I just bought a Lee die ( bought an extra pin just in case... from reading the comments on Midway... but have run crimped primers & ran into a couple berdan primed cases, & nnot had a problem with my decapping pin ) I love mine... also switched to wet tumbling with stainless pins... I have ammo cans full of empty cases, as I was never really happy with corn cob tumbling, & using the brushes on my RCBS case prep center for cleaning pockets after tumbling...
totally love my set up now, & have been going through all my ammo cans of emptys & making them look new...
just don't forget to size them later ( they'll look so nice, you want to just load them )
one of the reasons I started with my current routine, is I've scratched a sizing die, by sizing & decapping, before cleaning, & some how got some grit into the system... not that dies are super expensive, but I'd rather wear them out from use, than throw them out all scratched up...
__________________
In life you either make dust or eat dust...
Last edited by Magnum Wheel Man; February 11, 2013 at 08:59 AM.
|