View Single Post
Old January 23, 2020, 10:25 PM   #10
P Flados
Senior Member
 
Join Date: January 8, 2017
Location: Wilmington NC
Posts: 242
A 10mm would be fun, but I would not be happy with the short effective range.

A 30 carbine would also be fun, but again I would not be happy with the short effective range.

A 350L is a lot more of a gun. The good (for now) is that brass and components are ok and getting better. However, the round has enough taper such that it requires a full length steel sizing die. Loading is not near as easy as 10mm. I would consider this round to be just as involved as loading for say a 300 BO.

I have a 357AR that can use 223 basic brass and be loaded with 357 mag dies. It would be hard to recommend this wildcat now that the 350L is out.

A 450 seems to be a bit much for the desired application.

I really do not have any great suggestions that line up with the OP. A lever action 357 or 44 might actually fit better than an autoloader.
P Flados is offline  
 
Page generated in 0.03814 seconds with 8 queries