View Single Post
Old October 28, 2012, 04:38 PM   #6
richfr
Member
 
Join Date: December 5, 2009
Location: France
Posts: 79
Thanks I used a polishing kit that attaches to a bench grinder. 3 different grade mops and 2 grades of compound.
I stripped the mags first then removed the blueing/coating with the coarse mop and then moved on to the finer ones once it had all gone. There are a few hard to get angles but if you keep at it you can get it all off. It took me around 2hrs to do the barrel, take down leaver and 2 mags.
The mags feed so much better in the mag well too.
richfr is offline  
 
Page generated in 0.03032 seconds with 8 queries