View Single Post
Old September 11, 2012, 07:05 PM   #1
North East Redneck
Senior Member
 
Join Date: June 6, 2012
Location: Berkshire Hills
Posts: 741
1860 Army, made in Belgium

Looked at an 1860 Army today. Says made in Belgium. They wanted $350. Way to much for me, I would prefer to buy new for that price. Question, are these revolvers any good? When were they made? It seemed like a nice gun, looked nice. But the pins on the frame seemed like they had play when the barrel assembly was placed on them. Is this normal? Perhaps I said that wrong, the pins didn't move, the holes in the barrel seemed loose, even with the wedge in place. I do want an 1860, but I'm leaning towards one from the Taylors catalog. Am I correct in my thinking on this?
Also, the one I looked at was a steel frame, in case the pin to hole question would be different on a brass framed revolver, not that it should be, just wanted to clarify.
__________________
NRA Patron Member
SAF Life Member
GOAL Member

Last edited by North East Redneck; September 11, 2012 at 07:44 PM.
North East Redneck is offline  
 
Page generated in 0.03442 seconds with 8 queries