View Single Post
Old July 16, 2021, 05:18 PM   #5
Senior Member
Join Date: March 21, 2012
Location: Indianapolis, IN
Posts: 2,070
Originally Posted by ballardw View Post
Quite often you'll find that metal content affects size as dropped after cooling.

This link has one shrinkage chart as an example and includes .357.

You want to check the makers recommendations or actual mould size.
Some moulds and alloys may not need any sizing, others yes depending which actual diameter you want.

May want to jump over to if you haven't been there yet. You may get answers regarding specific moulds and alloys.
Just signed up. I have a LOT of learning to do.
I don't believe in "range fodder" that is why I reload.
Shadow9mm is offline  
Page generated in 0.02370 seconds with 8 queries