44AMP
Quote:
You're overthinking things a little. Go check the base of a new factory round.
It's going to be smaller than the spec.
Unless there is a +/- on the spec, or other information, always assume it is the maximum allowed.
|
That's good to know. I did measure some new rounds and got the same .4145 measurement just above the base. The new rounds measure the same until a little further up the case then it gets progressively smaller... on the new round. I guess I was expecting the sizer to bring the case back to original dimensions.
__________________
The duty of a Patriot is to protect his country from it's government.: Thomas Paine
NRA, TSRA, TFC Member
|