View Single Post
Old May 9, 2019, 04:38 PM   #2
Scorch
Senior Member
 
Join Date: February 13, 2006
Location: Washington state
Posts: 13,703
1- Push the cocking piece as far to the rear as you can by using the sear surface on the edge of a bench/table and pushing down, slip a penny in between the cocking piece and the bolt shroud. Unscrew the bolt shroud by turning the bolt shroud counterclockwise.

2- Push the firing pin in as far as it will go and remove the cocking piece by turning 90 degrees and slipping it off. You can now remove the safety for clean and lube as well.

3- Put the extractor claw to the bottom of the bolt (no retaining groove on the bottom) and push the claw forward to remove it.

4- Clean the parts, reinstall in reverse order.

Remember to capture the firing pin with the penny when screwing the bolt shroud into the bolt body.
__________________
Never try to educate someone who resists knowledge at all costs.
But what do I know?
Summit Arms Services
Taylor Machine
Scorch is offline  
 
Page generated in 0.03261 seconds with 8 queries