View Single Post
Old May 4, 2019, 06:42 AM   #11
Nathan
Senior Member
 
Join Date: July 1, 2001
Posts: 4,778
To me, it is all about your requirements. If you can accept slightly heavy, lower quality materials, made in the Far East, it is probably ok.

Think about what makes handguards expensive. To me it is usually their alignment system to the upper; strength of attachment to the nut; and their ability to not deflect on the end under slug pressure.

How does yours do these things? It will be clear good or bad after install.
Nathan is offline  
 
Page generated in 0.03110 seconds with 8 queries