The Firing Line Forums - View Single Post

tpcollins · August 11, 2021, 04:19 PM

I used some PC-7 epoxy (I think it’s an automotive epoxy similar to JB Weld) to bed a DNZ Grim Reaper one piece mount to my rifle. I also slipped a piece of .015”brass shim at the rear edge so I could get the maximum out of the Leupold CDS.

Other than scrape the heck out of the bottom with a knife, is there a chemical that would soften it easier for removal? I was hoping acetone might help? Thanks.

August 11, 2021, 04:19 PM	#1
tpcollins Senior Member Join Date: February 18, 2009 Location: SE Michigan Posts: 558	Removing bedding epoxy from mount I used some PC-7 epoxy (I think it’s an automotive epoxy similar to JB Weld) to bed a DNZ Grim Reaper one piece mount to my rifle. I also slipped a piece of .015”brass shim at the rear edge so I could get the maximum out of the Leupold CDS. Other than scrape the heck out of the bottom with a knife, is there a chemical that would soften it easier for removal? I was hoping acetone might help? Thanks.