The Firing Line Forums - View Single Post

Quizcat · May 3, 2020, 01:01 PM

Well, I haven't installed the muzzle break yet. I let the JB WELD fully cure in the groove first, and will use some Rocksett on the threads as a thread locker, so the muzzle brake doesn't work loose over time from the rifle is being fired.

Do you mean that once the brake is installed over the cured JB Weld in the groove, that the JB Weld will change consistency to the point that it might make the muzzle break more difficult to remove?

May 3, 2020, 01:01 PM	#11
Quizcat Member Join Date: August 19, 2012 Location: Missouri Posts: 54	Well, I haven't installed the muzzle break yet. I let the JB WELD fully cure in the groove first, and will use some Rocksett on the threads as a thread locker, so the muzzle brake doesn't work loose over time from the rifle is being fired. Do you mean that once the brake is installed over the cured JB Weld in the groove, that the JB Weld will change consistency to the point that it might make the muzzle break more difficult to remove? Last edited by Quizcat; May 3, 2020 at 01:10 PM.