View Single Post
Old January 5, 2019, 11:15 PM   #18
JohnKSa
Staff
 
Join Date: February 12, 2001
Location: DFW Area
Posts: 25,564
A lightened slide on a 9mm pistol in combination with a 960 Rowland conversion could be an "interesting" combination. And not in the good sense of "interesting".

I would recommend talking to Rowland about the advisability of such a course of action before spending too much money on it.

The Glock action (and other similar locked breech recoil operated pistol actions) balances slide/barrel momentum with bullet momentum. A high-velocity, heavy bullet load will increase bullet momentum significantly. That, in turn, combined with a lightened slide will increase slide velocity two ways. Higher momentum imparted by the heavier & faster bullet and less slide/barrel mass on the other side of the equation.

Most guns work best (and last best) in a fairly narrow range of slide velocities. Too low and malfunctions become an issue. Too high can cause both malfunctions and a significant decrease in service life--even potentially dangerous situations.
__________________
Do you know about the TEXAS State Rifle Association?
JohnKSa is offline  
 
Page generated in 0.02624 seconds with 7 queries