View Single Post
Old October 15, 2016, 11:43 AM   #17
snuffy
Senior Member
 
Join Date: May 21, 2001
Location: Oshkosh wi.
Posts: 3,055
Here's how to measure how much lift there is during operation of any press that has interchangeable tool heads/turrets.



That's my Dillon 650. I did a similar test on my classic turret, I just didn't take pictures, and didn't record my findings. But I can tell you that the amount of lift IS consistent from one to the next, AND it also levels out in the back of the turret disc when under full pressure like sizing and bullet seating.
snuffy is offline  
 
Page generated in 0.02531 seconds with 7 queries