The Firing Line Forums - View Single Post

alexcue · October 10, 2016, 05:23 PM

I would assume that as long as you put it into the same turret there would be no change. If you swapped turret presses, then you might have a problem. But this is no different than say an XL650, if you had two and tried to swap the toolheads, you might introduce a problem.

October 10, 2016, 05:23 PM	#4
alexcue Senior Member Join Date: July 28, 2015 Location: Los Angeles, CA Posts: 134	I would assume that as long as you put it into the same turret there would be no change. If you swapped turret presses, then you might have a problem. But this is no different than say an XL650, if you had two and tried to swap the toolheads, you might introduce a problem.