|
I size all new brass
For me not to requires too much trust
( I have worked in factories, and I learned that SH!! happens )
( I was not there when it was made, boxed, packaged, shipped,
put on the shelf or when the package was dropped, stepped on
or played with by those that handled it )
Problems I have found with new brass --
bent necks
NO flash hole
Off center flash hole
NO neck ( bottle neck case )
Made with 2 pieces of brass (not on purpose )
NO primer pocket
Never been formed ( still just a round disk )
Stage how these defects got though quality control
So when I size, do the primer pockets, do the flash holes,
trim and chamfer, I WILL find a defective case
|