The Firing Line Forums - View Single Post

chris in va · August 3, 2014, 05:08 AM

I've been shooting lead through my CX4 for a few months with few accuracy issues...until today.

It started with laser accuracy for a couple mags then I started getting buckshot patterns. Thinking my red dot worked loose I flipped up the irons with similar results.

At that point I quit shooting. Once home I disassembled and discovered a 'slug' of lead fouling on one small spot of the rifling. It was completely level and flush with the lands, something I haven't seen before. Just one spot in a groove, nowhere else.

It took quite a bit of scrubbing with chore boy to get it out. I guess my question is, how did this happen and what can I do to prevent it in the future? It was about 2" from the chamber. I'm using my usual 45-45-10 lube mix.

Should I start bringing the cleaning rod with me to the range?

August 3, 2014, 05:08 AM	#1
chris in va Senior Member Join Date: December 26, 2004 Location: Louisville KY Posts: 13,806	9mm carbine + lead = odd I've been shooting lead through my CX4 for a few months with few accuracy issues...until today. It started with laser accuracy for a couple mags then I started getting buckshot patterns. Thinking my red dot worked loose I flipped up the irons with similar results. At that point I quit shooting. Once home I disassembled and discovered a 'slug' of lead fouling on one small spot of the rifling. It was completely level and flush with the lands, something I haven't seen before. Just one spot in a groove, nowhere else. It took quite a bit of scrubbing with chore boy to get it out. I guess my question is, how did this happen and what can I do to prevent it in the future? It was about 2" from the chamber. I'm using my usual 45-45-10 lube mix. Should I start bringing the cleaning rod with me to the range?