View Single Post
Old October 21, 2013, 01:31 PM   #1
Senior Member
Join Date: July 21, 2011
Location: Idaho
Posts: 7,729
my bubba mosin nagant is goign through it again.

hello all,
I have a mosin nagant that I bubba'd and don't like it so I am changing the configuration a bit. I'm going to take the ATI scope mount off as the new stock will have a built in scope mount so I have questions. what is the best way to deal with the D&T on the receiver?
1. get some shorter screws and just locktite them in.

2. fill in with some sort of solder?

3. ignore them and hope I never have a case rupture?
ignore my complete lack of capitalization. I still have no problem correcting your grammar.
I never said half the stuff people said I did-Albert Einstein
You can't believe everything you read on the internet-Benjamin Franklin
tahunua001 is offline  
Page generated in 0.05480 seconds with 7 queries