View Single Post
Old August 27, 2013, 09:18 PM   #16
Senior Member
Join Date: July 15, 2006
Location: Fern Creek ,KY and Metro Louisville at large
Posts: 425
Thanks for the tip, I'm not sure if what I did counts as "honing", but I did polish the mating surfaces to a high shine finish, as well as replace the trigger spring with a spare I had on hand one that was not so ridiculously stiff.

I'll keep my eye on it though, It won't be that big of a deal to just slap a new FCG in if needed.

Does take a a lot to cut past the surface case hardening.

My rifle was purchased in 90 and is still stock.
Minus a new FCG
I bought a NM FCG and that is hardened and can be polished/honed
CW Shooters Supply Inc
Machine Shop and Finishing Services to the trade and public
guncrank is offline  
Page generated in 0.03569 seconds with 7 queries