View Single Post
Old August 19, 2013, 07:07 PM   #16
Senior Member
Join Date: September 8, 2010
Location: New Mexico
Posts: 612
I never liked ether one of those. Sooner or latter you will double clutch the handle when you get a primer hang up or a case not entering a die just right. Every time you move the handle it acting upon the powder drop.
You can work around it. But its a serious pain in the butt.

Case activated linkage and a powder check die is the only way to go.

That's exactly what I tried to tell the O.P. in post 2. RCBS dumped that drop system for a reason.....and it's not that expensive to change it.
GWS is offline  
Page generated in 0.03206 seconds with 7 queries