View Single Post
Old August 5, 2013, 09:36 PM   #2
Senior Member
Join Date: September 6, 2012
Location: Lakewood, CO
Posts: 1,054
Is the hammer spring installed correctly? one of the real long wires coming off of the hammer spring is what holds the trigger pin in position, the long wire fits down in the groove on the trigger pin to retain it in position.

The trigger pin should not be a roll pin, it is a solid pin with a couple grooves cut in it.

On the rare occasion I had to deal with PSA customer service, I had no complaints. I called them on the telephone though.
NRA Lifetime Member Since 1999

"I ask, sir, what is the militia? It is the whole people except for a few public officials." George Mason
iraiam is offline  
Page generated in 0.03320 seconds with 7 queries