View Single Post
Old July 2, 2013, 09:08 AM   #31
Senior Member
Join Date: October 28, 2006
Location: South Central Michigan...near Ohio, Indiana.
Posts: 5,024
Has that pin on the trigger been changed?
Not to my knowledge.

How about the lever that cams on the pin?
No, and I checked it for flatness to make sure it was not bent.

I considered trying to push the pin further in the trigger, but did not want to subject the pin to bending or breaking...I do not know how tight the pin is in its hole in the trigger. The shim seemed like the safest and easiest to undo route.

The pin sticks out of the trigger on both sides, but I did not notice any function for it on the outer side of the trigger. Did I miss something? Does the pin, proud of the trigger, on the opposite side from the lever engage anything?
dahermit is offline  
Page generated in 0.03372 seconds with 7 queries