View Single Post
Old July 1, 2013, 03:11 PM   #29
Senior Member
Join Date: October 28, 2006
Location: South Central Michigan...near Ohio, Indiana.
Posts: 5,040
The Colt is developing the habit of the pin on the trigger that works the "safety" (AKA hammer block), to come out of the slot. I put a round shim between the trigger and the side plate. Is this a common problem with Colt's and is the remedy a good one, or is there something better to try?
dahermit is offline  
Page generated in 0.03448 seconds with 7 queries