View Single Post
Old May 17, 2013, 09:57 AM   #41
Senior Member
Join Date: April 19, 2012
Location: Western PA
Posts: 3,502
Double checked gas key by instering bolt really slow and felt no snags. Also did not see any junk near gas block so I am really thinking that I dont have a gas issue. After thinking about it more, the YHM gas block has a HUGE gas hole compared to the one on barrel so if I missed, I woulda had to miss by quite a bit and the thing looks really, really straight.
Oops. I wrote my last post without realizing there was a whole second page of responses that already covered what I wrote. However, I still would recommend doing the check on gas tube/gas key alignment the way I described; when you check it with the BCG fully assembled it can sometimes be less obvious what's happening.
0331: "Accuracy by volume."
Theohazard is offline  
Page generated in 0.05235 seconds with 7 queries