View Single Post
Old May 7, 2013, 11:42 PM   #11
Senior Member
Join Date: September 9, 2012
Location: Texas
Posts: 373
bullet seating most important
If the neck of the cartridge is straight, how can the bullet seat anyway but straight? Ohhhh, I'm pretty sure I'll regret asking that question...

I know Redding makes a special, bullet-seating die that uses a micrometer to set depth. But I just use the normal die. Are there steps I need to take regarding the neck besides my full-length resizing die?
FLChinook is offline  
Page generated in 0.04124 seconds with 7 queries