View Single Post
Old May 6, 2013, 02:37 PM   #22
Doc Hoy
Senior Member
Join Date: October 24, 2008
Location: Chesapeake, VA
Posts: 5,105
When I was looking into a situation....

....requiring the measring of the chambers, I looked unsuccessfully for gages small enough to fit inside a .31 caliber chamber.

Actually the situation was very similar to this one. I could not get balls to fit my 1863 Remingtons. Having bought the .315 mold, I was getting the same problem that Craig is having.

Anyway, I tried several places looking for gage sets that would work inside a .31 and found nothing at anything like a reasonable price.

Any leads, tips or suggestions?


My reading of history convinces me that most bad government results from too much government. Thomas Jefferson
Doc Hoy is offline  
Page generated in 0.03373 seconds with 7 queries