View Single Post
Old April 23, 2013, 06:07 PM   #9
James K
Join Date: March 17, 1999
Posts: 24,160
It sounds like something is interfering with the slide when the trigger is not pressed. Since the trigger is pulled when firing, the problem does not happen then, only when the slide is operated manually. I have no idea where the interference is, but I would look at the sear bar and firing pin block, also at the sear bar and the trigger area. It might work itself out by firing, but there is no way to be sure.

Jim K
James K is offline  
Page generated in 0.03656 seconds with 7 queries