View Single Post
Old April 11, 2013, 11:19 AM   #9
Senior Member
Join Date: March 5, 2013
Location: NW Houston TX
Posts: 156
I am finding that out Thankfully the Woodcraft shop listed above is only 15 minutes away so when I am ready to "pull the trigger" (pun intended) I can go there and find it out

I take it you would have to go to a woodworking shop to get the checkering done?

Also if I get a hard enough wood, and wanted to engrave some stuff using my dremel, as long as I didn't go too deep that should be fine right?
Raised with guns only to realize how much I DIDN'T know. Newly acquired personal inventory is increasing, feed my obsession for knowledge!
Skitter is offline  
Page generated in 0.03304 seconds with 7 queries