Thread: 2 bore pistol
View Single Post
Old March 26, 2013, 09:46 PM   #32
Senior Member
Join Date: February 25, 2013
Posts: 249

got the lugs welded in place, i will use a vertical belt sander to plain out the large flat surface the barrel will mount to. and spend about a week with a belt sander and file to clean up the excess welds on the other side. i will then grind the sides of the lugs to match the diameter of the barrel. the lugs had weld channels grinded in before i welded
Attached Images
File Type: jpg 085.jpg (240.1 KB, 100 views)
nanewt02 is offline  
Page generated in 0.03618 seconds with 8 queries