View Single Post
Old March 25, 2013, 06:19 PM   #4
Senior Member
Join Date: December 28, 2009
Location: North Central Illinois
Posts: 1,804
I agree with the rough chamber. My NEF Handi Rifle would stick brass with “warm loads”. The primers showed no signs of pressure, but on occasion a spent brass would stick. I could see tooling marks in the chamber from the day it was new. I wrapped some 1000 grit sandpaper around a bore mop about the same size as the chamber and soothed the chamber a bit. No, not with an electric drill, just by hand. Took quite a while, but no more sticking brass. It didn't effect the accuracy, becuase it will shoot one inch groups with about any good ammo, and my best reload / best group last summer was 0.44 inch 100 yard group.
Mike38 is offline  
Page generated in 0.03410 seconds with 7 queries