View Single Post
Old March 24, 2013, 02:17 PM   #16
Walt Sherrill
Senior Member
Join Date: February 15, 1999
Location: Winston-Salem, NC USA
Posts: 6,026
I use bronze wire brushes...all the time on my barrels..../ after every range trip ( usually 200 rds or so ) get the jacketed plating out of the grooves in the barrel...
While bronze brushes are softer than the barrel metal, a lot of use of wire brushes WILL begin to wear the barrel -- just like you can use sticks to rub a groove in concrete or marble or granite. It takes a while, but it WILL happen.
Walt Sherrill is offline  
Page generated in 0.05271 seconds with 7 queries