View Single Post
Old March 22, 2013, 02:21 AM   #2
Metal god
Senior Member
Join Date: April 10, 2012
Location: San Diego CA
Posts: 3,693
I have a couple pairs of those . They're OK but would not use them on heavy recoiling rifle . One set is on my model 60 .22 the other is a extra high set for a AR . There are screws on both sides so you can adjust for windage with the rings when bore sighting . It works but IMO not really needed . I have almost maxed out my elevation with MOA bases but have never came close to maxing out my windage when sighting in a scope . As for the screws Home Depot , Lowe's , Dixie Line , local hardware store I have even had some luck at a boating supply store . Almost always SS screws there

I'd keep them as spares . They can be used in a pinch and replaced quickly
Tolerate- allow the existence, occurrence, or practice of something that one does not necessarily like or agree with , without interference.
If you have some time IMO this is worth a listen/watch but it takes a few minutes to really get going . or a picture of Mohamed
Metal god is offline  
Page generated in 0.08205 seconds with 7 queries