View Single Post
Old March 12, 2013, 02:01 AM   #6
Senior Member
Join Date: January 3, 2012
Location: Justin Texas
Posts: 311
The tap is just 5/16-36 and will pay for itself in short order as you can make any number of "modified cases" with it.

I believe you're going to need some kind of a bullet comparator to actually measure to the ogive, once you extract the modified case.

(I'm aware there are various photos showing measuring the OAL to the tip of the bullet, as the name of the product implies, but this can vary considerably between bullets even from the same manufacturing run. The ogive is the part that touches the lands.)
Is there some info missing from here? Also, I need pictures b/c I am not good at visualizing instructions that I read.
My great great grandfather was an old Indian fighter.
My great great grandmother was an old Indian.
cdbeagle is offline  
Page generated in 0.03209 seconds with 7 queries