Thread: 1917 eddystone
View Single Post
Old March 9, 2013, 08:22 PM   #4
James K
Join Date: March 17, 1999
Posts: 24,160
To mount a scope properly, the gunsmith will have to weld a steel block into that hole in the rear of the receiver (intended to lighten the rifle - it didn't help much). Othewise, there is no place to drill the hole(s) for the mount.

That will probably require rebluing the action, since it would be difficult (but maybe not impossible) to do that welding without damaging the bluing.

Jim K
James K is offline  
Page generated in 0.03214 seconds with 7 queries