View Single Post
Old February 27, 2013, 05:03 AM   #49
Senior Member
Join Date: January 7, 2012
Location: Auburn, AL.
Posts: 2,116
If you wanna throw a mic on the pin to that one and hit me with the measurement, I'll do my best to spin the pin cavity to match so they're all interchangeable between the two molds. You should have one flat for solid/adjustable and one straight with a radius?
Will do! And yes, there are two pins on this one, a flat one and a round one.
Have a Colt and a smile.
Beagle333 is offline  
Page generated in 0.07028 seconds with 7 queries