View Single Post
Old February 26, 2013, 12:30 PM   #6
Join Date: March 4, 2005
Location: Ohio
Posts: 13,648
If he's using the Lee Deluxe set, then he's got their collet die for neck sizing, which sizes the neck by pressing it inward against a mandrel rather than by sliding it into a constriction, as most dies do. It should be less prone to scratching for that reason, though, personally, I still get all the grit off the outside of the case and the carbon out of the inside of the neck to achieve the most uniform bullet pull. I then also set the shoulder back about a thousandth in a body die, but that's a whole other discussion.
Gunsite Orange Hat Family Member
CMP Certified GSM Master Instructor
NRA Certified Rifle Instructor
NRA Benefactor Member
Unclenick is offline  
Page generated in 0.06522 seconds with 7 queries