View Single Post
Old February 22, 2013, 10:49 PM   #1
Junior Member
Join Date: February 22, 2013
Location: Charleston, WV
Posts: 1
H-S Precision Remington 700 Fitment Issue...

Hello everyone!

I hate for my first post to be a plea for help, but it is! I'll go ahead and say that working with bolt actions rifles is fairly new to me, so please, bear with me!

I purchased the gun in question, a Remington 700 SPS Tactical .308, about a year ago. I loved everything about the rifle, but the factory hogue stock. Today, I thought I was finally going to change that! I purchased a H-S Precision stock from a local individual. It had been on one of his rifles (Supposedly), but he had since parted with the barrel, and no longer needed the stock. I am unsure of the model, I was just told it would fit a 700 SA BDL.

Everything seemed to go smoothly, until i went to put the floor plate back into place and realized the trigger group was a little too close to one side of the stock.

The bolt holes all lined up, so I'm sure it was in the stock straight. Everything fit fine when I put it back in the hogue.

Am I doing something wrong?

Thanks in advance!

LowStandards is offline  
Page generated in 0.05455 seconds with 7 queries