View Single Post
Old February 22, 2013, 01:12 AM   #85
Join Date: February 12, 2001
Location: DFW Area
Posts: 20,910
I did not, could not send Federal the casing as it was welded into the gun.
This, alone, is sufficient evidence that the ammunition was massively overpressure. There is no firearm-induced malfunction that could result in the case being welded to the chamber of a firearm that was operating normally up until that point.

I think that many people don't understand that there are often very obvious clues as to whether a catastrophic incident was the result of an ammunition problem or a firearm problem.
Did you know that there is a TEXAS State Rifle Association?
JohnKSa is offline  
Page generated in 0.03259 seconds with 7 queries