View Single Post
Old February 17, 2013, 06:31 PM   #5
Join Date: August 23, 2006
Location: Los Angeles, CA
Posts: 53
A few problem holes

Originally Posted by guncrank View Post
Customer wants to have a scope mounted to use.
I would start by figuring out how to put a scope on it.
Then, plug the un-used holes with plug screws, tig weld the tops and blend the bottoms inside the chamber.
Then mount the scope base.
Make sure all the screws fully protrude inside the chamber so you end up with them filling all of the holes inside the chamber.
AR15barrels is offline  
Page generated in 0.03394 seconds with 7 queries