View Single Post
Old February 13, 2013, 03:24 PM   #70
Bart Noir
Senior Member
Join Date: August 5, 2000
Location: Puget Sound, USA
Posts: 2,060
I had the .40 but sold it as I didn't like the balance. The heavier slide just wasn't right for me.

And I had a 9mm HP that had been made in India. At some point after WW2, the Canadian company Inglis (which built Hi Powers and BREN guns) sold the tooling to India. The finish was simple mil-spec Parkerizing and the front sight was staked in crooked. But it worked. I just wanted nicer ones, which I now have.

But the round hammer will bite my hand all the time. I guess I hold it too high, or have a deformed right hand The Mark III spur hammer has never bitten my hand.

Anybody else have this issue with the round hammer?

Bart Noir
Be of good cheer and mindful of your gun muzzle!
Bart Noir is offline  
Page generated in 0.03382 seconds with 7 queries