View Single Post
Old February 11, 2013, 11:22 PM   #11
Senior Member
Join Date: February 8, 2010
Location: MN
Posts: 406
Agree on the Forsters. I called them to get the screw size because I wanted to switch to Allens and found out they had changed to them. Good move on their part. With Lee, you continue to get what you pay for. They have their place but not on my bench.
I bought a few of their rings nearly a year ago for just one set of Lee dies, as the Lee die rings, don't quite work in my Co-Ax... and the rings came with cheap aluminum screws. I liked them, but switched the screws out with something I found at Fastenal. I ordered the 12 pack a few months later and by that time, they were changed out to allen-headed screws. Definitely nicer!
Jbotto is offline  
Page generated in 0.03917 seconds with 7 queries