Thread: M1 carbine help
View Single Post
Old February 3, 2013, 09:11 PM   #4
Junior Member
Join Date: February 1, 2013
Posts: 5
thanks guys, it wasn't hanging in the barrel, it just wouldn't eject causing the incoming shell to lodge half way into the chamber.
I took it back down this afternoon and found a burr on the extractor, removed the burr, cleaned it up, went out and shot a few rounds and is as good as new

much thanks
"Our country is in danger, but not to be despaired of . . . On you depend the fortunes of America. You are to decide the important question, on which rest the happiness and liberty of millions yet unborn. Act worthy of yourselves."

No one is bound to obey an unconstitutional law and no courts are bound to enforce it
Nitro96 is offline  
Page generated in 0.03807 seconds with 7 queries