View Single Post
Old February 3, 2013, 02:20 PM   #2
Join Date: March 4, 2005
Location: Ohio
Posts: 13,741
In general, you want to keep antimony content low in hollow point alloys because it increases brittleness. After that, impact velocity and width of the hollow point come into consideration. Harder (more tin) for higher velocities and wider hollow points, and vice versa.

This article discusses it further.
Gunsite Orange Hat Family Member
CMP Certified GSM Master Instructor
NRA Certified Rifle Instructor
NRA Benefactor Member
Unclenick is offline  
Page generated in 0.05615 seconds with 7 queries