Thread
:
Hornady Sizing Die Problem!
View Single Post
February 1, 2013, 09:06 PM
#
17
dickttx
Senior Member
Join Date: May 29, 2011
Location: Fort Worth
Posts: 500
As a simple test I would remove the decapping pin from the sizing die and run a few cases through the die. Then try some bullets to see if you have enough neck tension. If you do then your expander is too large. If not your sizing die is too large.
dickttx
View Public Profile
Find More Posts by dickttx
Page generated in
0.02406
seconds with
7
queries