View Single Post
Old February 1, 2013, 07:51 AM   #2
Bart B.
Senior Member
Join Date: February 15, 2009
Posts: 6,318
This is confusing:
So it says it is resized so I DID NOT put my sizing die. I started putting brass in and ran some through the press. When i seated the bullets they were tight and couldn't move the bullet. So that is why I am saying it might be my sizing die.
Sounds contradictory.

Are you resizing that brass with your full length sizing die?

What happens when you try to seat a bullet in one of those cases without using a sizing die on it first?
US Navy Distinguished Marksman Badge 153
Former US Navy & Palma Rifle Team Member
NRA High Power Master & Long Range High Master
NRA Smallbore Prone Master
Bart B. is offline  
Page generated in 0.03682 seconds with 7 queries