View Single Post
Old January 24, 2013, 10:22 AM   #6
Magnum Wheel Man
Senior Member
Join Date: July 26, 2006
Location: Southern Minnesota
Posts: 9,333
the right type of "plastic" coating would probably be best, I know they have coated cleaning rods, so there are coating materials that could take the solvents long term...

I could ask my local electrical contractor we use at the plant I manage about solvent resistant heat shrink tube...

was thinking about sanding a rounded tip on the rods originally, but there may be slide on tips that are also solvent resistant ???
In life you either make dust or eat dust...
Magnum Wheel Man is offline  
Page generated in 0.04121 seconds with 7 queries