View Single Post
Old January 14, 2013, 08:02 AM   #7
Doc Hoy
Senior Member
Join Date: October 24, 2008
Location: Chesapeake, VA
Posts: 5,105
The quest for parts begins....

As I said, my Geroco Peacemaker broke yesterday.

Indeed the hand pin broke into to pieces. I have both of the pieces and as it turns out, none of the parts I have will fit.

In addition, the cam on the hammer is worn and the pistol no longer cycles properly.

I looked at the hammers that I have and it appears that even if I can get the cams out, they won't fit either. So not I am looking for parts.

I will try DGW, VTI, Midway and Numrich. Do y'all have any additional suggestons?

This is a Geroco Peacemaker clone in .357.



My reading of history convinces me that most bad government results from too much government. Thomas Jefferson
Doc Hoy is offline  
Page generated in 0.05416 seconds with 7 queries